SCS is typically applied to hot band as it ships from the mill, but it also 'resuscitates' coils stored outside that accumulate rust and dirt, turning them into prime material. Even treadplate, in sheet form, can be SCS'd to remove rust and obtain a remarkably clean surface.
SCS Material Sizes
Coils
Width 24" – 76"
Thickness 0.030" – 0.250"
Max. Coil 60,000 lbs.
80" OD
Sheets
Width 24" – 74"
Thickness 0.043" – 0.500"
Length inquire with
Coils
Width 24" – 76"
Thickness 0.030" – 0.250"
Max. Coil 60,000 lbs.
80" OD
Sheets
Width 24" – 74"
Thickness 0.043" – 0.500"
Length inquire with
Sheets that will undergo SCS processing come from cut-to-length lines that use either stretcher-leveling, temper passing, tension leveling or aggressive roller leveling prior to blanking.
For coils, the SCS line combines in-line roller leveling with extreme tension generated by the recoiler. This gets the material very flat, reducing edge wave, bow and even some coil breaks, to achieve permanent shape correction.
For coils, the SCS line combines in-line roller leveling with extreme tension generated by the recoiler. This gets the material very flat, reducing edge wave, bow and even some coil breaks, to achieve permanent shape correction.
